|
Scarf Joint clamping setup
First the longer neck piece is clamped to the bench.
|
Then the smaller piece is flanked by two pieces to serve as clamping cauls. They are covered in packing tape to prevent gluing them to anything.
|
Here is a closeup. Notice how the lower piece does not cover the end of the wood. Leave at least 1/8".
|
Next tap the smaller piece onto the larger piece with a hammer. Light taps shoud drive out the glue.
|
Next clamp it all in place. Start with clamping the smaller piece to the bench very firmly so it does not move. Then clamp the cauls slowly applying pressure.
|
|